Skip to main content
Omnitracs Knowledge Base

Reset Macros

Forward macros are only used with Hours of Service in Omnitracs-equipped vehicles. They are not used when your vehicle is equipped any MCP device. If the forward and return macros were not properly defined, they are set to failure status. After the macro definitions have been corrected, they need to be reset in HOS for drivers to start using them.

  1. Click the Administration tab.
  2. Click Vehicle.
  3. Click the Reset Macros link on the right to open the Macro Reset page.
  4. Click the Reset button.
  5. In the confirmation box that displays, click the OK button.
  • Was this article helpful?