Skip to main content
KB_Header_SiteLogo.svg
Omnitracs Knowledge Base

Reset Macros

Forward macros are only used with Hours of Service in OmniTRACS-equipped vehicles. They are not used when your vehicle is equipped any MCP device. If the forward and return macros were not properly defined, they are set to failure status. After the macro definitions have been corrected, they need to be reset within HOS for drivers to start using them.

  1. Click the Administration tab.
  2. Click Vehicle.
  3. Click the Reset Macros link on the right to open the Macro Reset page.
  4. Click the Reset button.
  5. In the confirmation box that displays, click the OK button.

© 2020 Omnitracs, LLC. All rights reserved.
Omnitracs is a trademark of Omnitracs, LLC. All other trademarks are the property of their respective owners.

Omnitracs endeavors to ensure that the information in this document is correct and fairly stated, but Omnitracs is not liable for any errors or omissions. Published information may not be up to date, and it is important to confirm current status with Omnitracs. Specifications subject to change without notice.

This technical data may be subject to U.S. and international export, re-export or transfer (export) laws. Diversion contrary to U.S. and international law is strictly prohibited.

 

  • Was this article helpful?