The 1819 release is a patch release to 1812 and contains modifications to address a GPS date issue that occurred on November 2, 2019. Most of the impact was resolved by over-the-air patches. This 1819 firmware release provides a comprehensive resolution for the issue.
Hardware Requirements, Software Dependencies
This document covers a firmware release that supports MCN CA90-J9937-10 and higher and is composed of the following software:
- PAPI 200.12.50
- VIOP: 200.16.02
Most upgrades are done over-the-air. Both the firmware and the operating system are available for download on the Omnitracs Customer Portal (on the Support page, click Firmware/OS); refer to the following guides for upgrade procedures:
- MCP110: Windows XPE operating system builds OS129 and OS130
- MCP200: Windows XPE operating system builds OS29 and OS30
© 2020 Omnitracs, LLC. All rights reserved.
Omnitracs is a trademark of Omnitracs, LLC. All other trademarks are the property of their respective owners.
Omnitracs endeavors to ensure that the information in this document is correct and fairly stated, but Omnitracs is not liable for any errors or omissions. Published information may not be up to date, and it is important to confirm current status with Omnitracs. Specifications subject to change without notice.
This technical data may be subject to U.S. and international export, re-export or transfer (export) laws. Diversion contrary to U.S. and international law is strictly prohibited.