Skip to main content
Omnitracs Knowledge Base

MCP50 Version CA1391R Release Notes

The MCP50 CA1391R release includes improvements in the compilation of eRODS files.

Hardware Requirements, Software Dependencies

This release supports MCN CV90-JB424-100 and higher and is composed of the following software:

  • PAPI: 50.10.00
  • VIOP: 50.13.00
  • CoPilot® Truck™ (ALK): 9.64.787
  • Omnitracs Weigh Station Bypass provided by Drivewyze™ PreClear: 4.4.5
  • Mobile Data Capture: 1.0.216

Upgrade Procedures

Most upgrades are done over-the-air. Both the firmware and the operating system are available for download on the Omnitracs Customer Portal (on the Support page, click Firmware/OS); refer to the Installation and Troubleshooting Guide for upgrade procedures.

Note: If after over-the-air upgrade your drivers notice that vehicle inspection reports are lost, have them record their reports on paper until the unit is upgraded.

Compatibility

Compatible with Windows CE Operating System (OS) LT0033 or higher.

Note: Omnitracs suggests OS LT0038 or higher for best driver experience; this operating system is required to use the In-Cab Scanning, Mobile Data Capture, and Workflow 2.0 features.

© 2020 Omnitracs, LLC. All rights reserved.
Omnitracs is a trademark of Omnitracs, LLC. All other trademarks are the property of their respective owners.

Omnitracs endeavors to ensure that the information in this document is correct and fairly stated, but Omnitracs is not liable for any errors or omissions. Published information may not be up to date, and it is important to confirm current status with Omnitracs. Specifications subject to change without notice.

This technical data may be subject to U.S. and international export, re-export or transfer (export) laws. Diversion contrary to U.S. and international law is strictly prohibited.