Skip to main content
Omnitracs Knowledge Base

MCP50 Version CA1389R Release Notes

The 1389 release is a patch release to 1379 and contains modifications to address a GPS date issue that occurred on November 2, 2019. Most of the impact was resolved by over-the-air patches. This 1389 firmware release provides a comprehensive resolution for the issue.

Hardware Requirements, Software Dependencies

This release supports MCN CV90-JB424-100 and higher and is composed of the following software:

  • PAPI: 50.10.00
  • VIOP: 50.13.00
  • CoPilot® Truck™ (ALK): 9.64.787
  • Omnitracs Weigh Station Bypass provided by Drivewyze™ PreClear: 4.4.5
  • Mobile Data Capture: 1.0.216

Upgrade Procedures

Most upgrades are done over-the-air. Both the firmware and the operating system are available for download on the Omnitracs Customer Portal (on the Support page, click Firmware/OS); refer to the Installation and Troubleshooting Guide for upgrade procedures.

Note: If after over-the-air upgrade your drivers notice that vehicle inspection reports are lost, have them record their reports on paper until the unit is upgraded.

Compatibility

Compatible with Windows CE Operating System (OS) LT0033 or higher.

Note: Omnitracs suggests OS LT0038 or higher for best driver experience; this operating system is required to use the In-Cab Scanning, Mobile Data Capture, and Workflow 2.0 features.
  • Was this article helpful?