Hardware Requirements, Software Dependencies
This document covers a firmware release that supports MCN CA90-J9937-10 and higher and is composed of the following software:
- PAPI 200.12.50
- VIOP: 200.16.02
Most upgrades are done over-the-air. Both the firmware and the operating system are available for download on the Omnitracs Customer Portal (on the Support page, click Firmware/OS); refer to the following guides for upgrade procedures:
- MCP200: Windows XPE operating system builds OS29 and OS30
Features and Enhancements
Users should use MCP200 AA1822R unless they are communicating through a 500K J1939 bus. Those using the 500K data bus should continue to use version AA1819R.
- When the SDM GPS is used, the 1024 week correction is no longer applied to the GPS date and time. This fix also corrects the GPS forward date for units that use SDM satellite mode.
- Improvements have been made in the compilation of eRODS files.
© 2020 Omnitracs, LLC. All rights reserved.
Omnitracs is a trademark of Omnitracs, LLC. All other trademarks are the property of their respective owners.
Omnitracs endeavors to ensure that the information in this document is correct and fairly stated, but Omnitracs is not liable for any errors or omissions. Published information may not be up to date, and it is important to confirm current status with Omnitracs. Specifications subject to change without notice.
This technical data may be subject to U.S. and international export, re-export or transfer (export) laws. Diversion contrary to U.S. and international law is strictly prohibited.